User's Manual

17 / 48
S1008_X-8E_jh_V1
Meaning of the individual menu items
RF SYSTEM = HoTT for receiver (GR-4/12/16/18/24/32)
HoTT V2 for receiver with SUMD-V2 (GR-8)
BIND = Displays bound receiver channels
RF ON/OFF = Displays if RF is switched on or off
RANGE TEST = Range test (see chapter “Range test”)
CH FUNCTION ==> (only available in HoTT V2 operation with
compatible receiver)
Channel features (CH FUNCTION)
Only available in HoTT V2 operation with compatible receiver!
Each channel is capable of the following signals:
 USR1m50 : ULTRA SIGNAL 1.5msec
 FSR3m00 : FAST SIGNAL 3.0msec
 SUMD-V2 : FAST SIGNAL BUS 3.0msec
 NSR6m00 : NORMAL SIGNAL 6.0msec
 NSR12m0 : NORMAL SIGNAL 12.0msec
 NSR24m0 : NORMAL SIGNAL 24.0msec
Use this menu to adjust the servo properties by setting the indi-
vidual channel properties. (For more information refer to the
servo’s user’s manual.)
Attention
The SUMD-V2 setting can only be used for Graupner servos,
sensors and controllers that support this function!
Notice: To save receiver settings, follow the instructions on the
screen in the following order:
1. Switch receiver off
2. Switch transmitter off
3. Switch transmitter on
4. Switch receiver on
To verify the receiver settings are displayed, check the telemetry
menu.
BACK
NSR12m0
CH 3
NORMAL
SERVO
CH 4
CH 2
CH 1
CH
FUNCT
NSR12m0
NSR12m0
NSR12m0
BACK
NORMAL
SERVO
CH FUNCT
Reboot as follows:
1. Power receiver off
2. Switch transmitter off
3. Switch transmitter on
4. Power receiver on
OK
BACK
NORMAL
HOTT V2
RF SYSTEM
BIND
RF ON/OFF
R04
ON
RANGE TEST
OFF
99sec
CH FUNCTION
>>