User's Manual

16 / 48
S1008_X-8E_jh_V1
RF SET
Binding and range test
Binding
To establish a communication link, bind the Graupner-HoTT
receiver to the X-8E Graupner-HoTT transmitter. The binding
process has already been performed for the transmitter and the
receiver included. However, binding is required for each addi-
tional receiver added to this transmitter. To bind additional
receivers:
NOTE: The transmitter can be turned ON or OFF with one of
two buttons. When using the white button, the transmitter RF
functions are completely disabled and it will not be possible
to turn on the RF or bind a receiver.
1. Turn on the transmitter using the RED button. If no
receiver is bound to the model, select SET. Selecting SET
will bring up the bind finction of the RF SET menu.
2. Select the correct RF system. (HoTT V2 for the GR-8 or
HoTT for the GR-4.) GR-8: The red LED flashes slowly
when there is no communications link. GR-4: The red
LED glows solid red when there is no communications
link.
3. Press and hold the SET button on the receiver for about
3 seconds.
4. Press the BIND button on the transmitter.
5. The OFF will change to CHK momentarily.
6. If the bind is successful, the number of receiver channels
will be displayed. If not successful, the button will return
to OFF status.
Repeat the bind process until successful. It is all a matter of tim-
ing. (Counting "one thousand one, one thousand two, one
thousand three" will help with the timing.)
Receiver
Transmitter display
Binding button
BACK
NORMAL
HOTT V2
RF SYSTEM
BIND
TELEMETRY
OFF
ON