User Manual

4. TRIM
The trims are used to fine-tune the point where the servo returns to center.
(Adjustable from -37.5% to +37.5%)
ST: Use the ST-TRIM so your vehicle will go perfectly straight when the steering wheel is centered.
(Adjustable from -37.5% to +37.5%)
TH: Use the THR-TRIM to adjust the amount of brake that occurs when your engine’s idle is too low
or high and your ESC is not perfectly at neutral.
(Adjustable from -37.5% to +37.5%)
Fail Safe Mode Configuration
It should be programmed after binding process. The default value is “Free” mode.
Fail Safe is set to throttle channel (CH2)
Move your throttle to the position on which you act fail safe mode. Now touch and hold BIND button
for 3 sec until fail safe mode is set. (Buzzer beeps 3 times)
Press BIND button for 3 sec again and fail safe is deactivated. Now return to “Free” mode. (Buzzer
beeps twice) After returning to Free mode, turn your transmitter off so that Fail safe mode is acting
properly.