User Manual

Binding & RF Range Test
BIND
Press and hold Bind button for 3 sec while your receiver is powered on and then LED indicator is off.
Now press Bind button of your transmitter and then receiver’s LED indicator is off.
RF RANGE TEST
When BIND button is touched after the connection between transmitter and receiver, RF RANGE
TEST is now activated. RF TEST is continued during 90 seconds and it is automatically deactivated.
RF RANGE TEST is deactivated by touching BIND button during RF RANGE TEST mode.
Please note that your model is not controllable if your model is far away from you during Test mode
due to the short transmit distance.
Control Switch Functions
1. REV (Reverse Switch)
This is used to change the direction of the servo travel for proper control when activated.
If you steer right and the wheels go left, change the “ST” switch from “Nor” to “Rev” or “Rev” to “Nor” if
needed. The same applies to the throttle.
2. ST D/R (Steering Dual Rate)
It is used to adjust the overall travel of the steering servo. (Adjustable from 0 % to 150%)
3. TH EPA-FW, EPA-BR (TH EPA-FW, EPA-BR)
This is used for throttle end point adjustment and for brake and reverse amount.
(Adjustable from 0% to 150%)