User Manual

CH1 CONNECTOR

1) Port 1, 2 should be connected with the servo or ESC.

2) Port 3 supports low voltage warning alarm with beep and LED indicator.

In addition, it is available to use with telemetry sensor.

When using receiver battery (Nixx 4~5 cell, LiPo 2 cell), it needs to be connected to Port3.

As for low voltage warning alarm, the default value is 3.7V.

Caution: When using LiPo 2 cell for receiver battery, you may protect your battery from any damage

by using optional smart box, which ensures voltage adjustment and warning alarm function.

3) Port 4 (T/V connector) is designed that it will activate the beep and LED indicator when your engine

gets hot.

Warning alarm would be activated if the batter is discharged down to 70% from fully charged within

voltage range (1.0V~25.5V). If you connect the used battery which has already discharged capacity

instead of fully charged battery, the warning alarm will be activated when the capacity of the used

battery reaches down to 70% from its voltage capacity.

Caution: It is not allowed to connect your battery to T/V Connector directly. Please make sure to

connect with Voltage/Temperature sensor cable (S8362). This port is only for measurement for the

voltage of power battery. Please note that it is not for input power.

<Voltage/Temperature Sensor Configuration> - Item/Order No. S8362

Ex Voltage (+): Connect ESC power connector (+)

NTC Thermal: Connect Engine head

Connect sensor to Port 4(T/V Connector) as above. Temp sensor should be installed on engine head

and Volt sensor should be installed on ESC power connector(+).

Caution: Warning alarm may not be activated, depending on weather condition or mounting location.

If it is not activated, change mounting location or adjust temperature value with optional smart box

(Telemetry box). (Default value: 100℃)

Caution: For your safe use, we recommend fully charging your battery before use.

Warning alarm function is automatically activated when your battery capacity is lower than 70%,

regardless of power battery’s charging status.

4) Receiver Indicator LED’s

LED OFF: Very good signal condition

LED blinks: Not good signal condition

LED ON: No signal

10K/C

NTC Thermistor

Ex Voltage(+)