User Manual

1) Port 1, 2, 3, 4 should be connected to servo or ESC.

2) Port 5 supports low voltage warning alarm with beep and LED indicator.

In addition, it is available to use with telemetry sensor.

When using receiver battery (Nixx 4~5 cell, LiPo 2 cell), it needs to be connected to Port3.

As for low voltage warning alarm, the default value is 3.7V.

Caution: When using LiPo 2 cell for receiver battery, you may protect your battery from any damage

by using optional smart box, which ensures voltage adjustment and warning alarm function.

3) Port 5 is designed that it will activate the beep and LED indicator when your engine gets hot.

Caution: Regardless of receiver battery type, warning alarm is activated if battery capacity is lower

than 70%. Therefore, you need to use your model after fully charging battery.

Ex Voltage (+): Connect with ESC Power Connector(+)

NTC Thermistor: Connect with Engine Head

Connect sensor to Port 4 as above. Temp sensor should be installed on engine head and Volt sensor

should be installed on ESC power connector (+).

Caution: Warning alarm may not be activated, depending on weather condition or mounting location.

If it is not activated, change mounting location or adjust temperature value with optional smart box

(Telemetry box). (Default value: 100℃)

4) Receiver Indicator LED’s

LED OFF: Very good signal condition

LED blinks: Not good signal condition

LED ON: No signal

LED and Buzzer indication