User's Manual

31 / 107
3. Then, the message table shows “Pairing, please wait…” as shown below
4. After completing the pairing, the message table shows “Succeeded to pair!” on the home page, as shown
below. Then, please un-plug the transmitters and use it for the mirroring on your laptop.
If error-message “Configuration fail” is shown, please check the connection of USB/type C to keep stable after
plug-in, and try again.
Note: After each changing the SSID/Wi-Fi channel in menu, all the transmitters must be paired again!
When you buy additional transmitters or when a transmitter should be assigned to another Base-unit, the
transmitter must be paired again.
A transmitter can only be paired to one Base-unit at a time. The transmitter will always make connection to the
Base-unit it was last paired to.