User's Manual

12 / 107
ID
Name
Description
1
Line audio
output
2 channel analog audio output, Connect a 3.5mm mini-jack
PC connector from this jack to the Line in jack of an audio
system.
2
Rear USB3.0
connector
USB port, for USB dongle pairing, mouse control, USB touch
screen etc.
3
Reset
Reset button to restore to the factory default setting.
4
HDMI output
Connect an HDMI cable from this port to an
HD or 4K/HDMI2.0 display.
5
RS-232
Connect an RS-232 cable from this port to an RS-232 device.
(Note: No RS-232 port in model WMS-10 hardware.)
6
LAN Ethernet
port 1
100Mbps, Connect an Ethernet cable between
this jack and a LAN to connect WMS-40 to LAN.
7
LAN Ethernet
port 2
1000Mbps, Connect an Ethernet cable between
this jack and a LAN to connect WMS-40 to LAN. Support POE.
(Note: No LAN Port 2 in model WMS-10 hardware.)
8
DC Power socket
Connect the included power adapter to this socket, and
connect the plug to an available electrical outlet.
9
Antenna fixture
points
Screw up the included two antennas to these two ports.
Note: LAN port 2 and RS-232 port is only for WMS-20&WMS-40 in hardware.
USB port
 The USB port is used to update the software of the WMS-40.
 The USB port is used for pairing the dongle and base unit, when the transmitter is plugged-in.
 The USB port is used for connecting a mouse to create/upgrade Launcher by clicking Download button,
hide SSID, PASS, Wifi IP and Lan IP by clicking Info, check Security level button and control PC source
device, when a PC desktop is mirroring to the screen by plugging in the dongle.
 The USB port is used for connecting a USB-based touch screen to create/upgrade Launcher by clicking
Download button, hide SSID, PASS, Wifi IP and Lan IP by clicking Info, check Security level button and
control PC source device, when a PC desktop is mirroring to the screen by plugging in the dongle.
 The USB port is used for creating or upgrading Launcher by clicking Download button, when a USB stick is
plugged in.
3.1.3 Factory Reset
 Start up the Base unit.
 When the Home Screen is shown up, press the reset button at the rear panel of base unit. Press this button
with a pointed object, e.g. an unbent paper clip until the “Factory Reset” page is shown up as below, for at
least 2 seconds.
 The Base unit will reboot after 3 seconds to be default configuration.