User's Manual

107

PoweroverEthernet

If the LAN Ethernet switcher support POE (Power over Ethernet), it could power up the Base-unit instead of using

the external power adapter. (WMS-40 LAN2 P ort is support POE.)

4.4 Video Connection

1. Connect the HDMI Output of base unit to a 4K or Full-HD display by a HDMI cable.

2. Connect the power adapter to the base unit DC power socket and connect the other side plug to an

available electrical outlet and switch the base unit on.

3. After started, the system show the home page, as shown below.

4.5 Audio Connection

WirelessMedia transmitter can transmit the audio output of the PC/Lap-top, re-direct and send to the Base Unit

together with the video signal. The audio will be output at line levels from mini jack socket 3.5mm connector and

via the HDMI output connectors simultaneously.

It’s up to the user to decide whether or not to send the audio signal together with the video signal.

Audio via HDMI output

When your display/projector is connected via HDMI and it support audio together with video, then a separate

audio connection is not necessary. The audio signal is sent together with the video signal to the display. The

system is shown as below.