Operation Manual

96
7. Timer programs
7.1 Creatingtimerprograms
The switching commands are represented by the buttons , ,
and
. A timer program consists of several switching commands.
1. Clickontherespectivesymboltoselectaswitchingcommand.
Z
As soon as you place the mouse pointer on the graphic, it will change
into the selected symbol.
2. ClickwiththeleftmousebuttoninaeldtoplacetheONswitching
command.
In the case of an ON/OFF and a cycle switching command, click a second
timeinanothereldtoplacetheOFFswitchingcommand.
Z
Depending on the type of switching command, further settings windows
open
3. To change the time, pulse duration or period of a switching command, click
on the desired switching command in the table with the left mouse button.
The "up" and "down" arrow keys
canbeusedtosetdays(dd),hours
(hh),minutes(mm)andseconds(ss).
If you click outside the graphic, no switching command is placed and you
have to select the desired symbol for the switching command again.
The switching commands can also be created as follows:
1. Clickwiththerightmousebuttononanyplaceinthegraphic.
Z
Aselectioneldopens.
2. ClickonCreate new program and select the desired switching command.
3. Clickwiththeleftmousebuttoninthedesiredeldinthegraphictoplace
the OFF switching command.
or
1. ClickinthemenubaronEdit

New Program and select the desired
switching command.
2. Thenclickwiththeleftmousebuttoninthedesiredeldinthegraphicto
place the switching command.