Operation Manual

144
Transmitting timer programs to the hand-held
transmissiondevice(Timer

Handheldprogrammingdevice)
The timer must be in the taxxi mode,
see operating manual of the respective timer.
1. Press the Prog. key to select the respective memory space
–– P_1 .... P_4.
To transmit the time, press the Prog. key to select "c lo".
2. Place the IR interface of the handheld programming device directly on the two
IRdiodesofthetimer(holditsteady).
3. Press the in key once.
Z
The transmission is prepared, the corresponding program place and the
allocation inashalternately.
4. Press the in key once again.
Z
The data is transmitted. During the transmission, there is an acoustic
signal.
Z
If the data was transmitted correctly, the number of the program place is
displayed on the handheld programming device, e.g. P_1.
Z
If the data is transmitted incorrectly, there will be a short acoustic signal
and a corresponding error message Er x appears on the display.
Transmitting timer programs to the timer
(Handheldprogrammingdevice

Timer)
The timer must be in the taxxi mode,
see operating manual of the respective timer.
1. Press the Prog. key to select the respective memory space
–– P_1 .... P_4.
To transmit the time, press the Prog. key "c lo".
2. Place the IR interface of the handheld programming device directly on the two
IRdiodesofthetimer(holditsteady).
3. Press the out key once.
Z
The transmission is prepared, the corresponding program place and the
allocation outashalternately.
4. Press the out key once again.
Z
The data is transmitted. During the transmission, there is an acoustic
signal.
Z
If the data was transmitted correctly, the number of the program place is
displayed on the handheld programming device, e.g. P_1.
Z
If the data is transmitted incorrectly, there will be a short acoustic signal
and a corresponding error message Er x appears on the display.