User's Guide

65
LDX 100
User’s Guide
Note
Note
Go to the Operator Toolbox > User buttons menu and select the Eng Mode function to
change the switching mode (momentary or alternating) of the Eng button.
Hold the production (Prod) channel selection button to talk to the production channel.
Release to switch off the production channel.
Adjusting intercom volume
Use the rotary controls at the back panel of the camera to adjust the audio volume of the
three intercom channels:
Prod—adjusts the volume of the production channel intercom signal.
Prog—adjusts the volume of the program intercom channel signal.
Eng—adjusts the volume of the engineering intercom channel signal.
To adjust the audio volume of the signal from the Tracker headset microphone go to the
Configuration > Intercom menu and change the Cam Tracker lvl item.
Routing signals
By default, all three intercom channels are audible on both muffs (left and right) of the
camera headset. The routing of the intercom channels can be changed to personal
preference. Go to the
Configuration > Intercom menu to set up the routing:
Cam Prod—selects to which ear muff(s) of the camera headset the production
intercom channel is routed.
Cam Eng—selects to which ear muff(s) of the camera headset the engineering
intercom channel is routed.
Cam Prog—selects to which ear muff(s) of the camera headset the program intercom
channel is routed.
Cam Tracker—selects to which ear muff(s) of the camera headset the Tracker’s
microphone signal is routed (when a Tracker headset is connected).
Intercom microphone gain, 12V bias tee power supply and microphone on/off switches are
also available in this menu.
Adjusting sidetone volume
Sidetone levels (this is audio feedback from microphone to ear muffs) for camera and
Tracker headsets can be adjusted in the
Operator Toolbox > Intercom menu:
Cam Sidetone—adjusts the sidetone level of the camera operator’s headset from 0
(muted) to 99 (loudest).
Tracker Sidetone—adjusts the sidetone level of the Tracker’s headset from 0 (muted) to
99 (loudest).