User's Guide

LDX 100

User’s Guide

Back

Set up the viewfinder according to your own preferences; adjust viewing parameters, select

markers, message boxes and on-screen display times in the

Operator Toolbox menu.

(1) Mode switch

This switch determines the function of the Menu/Peak rotary control below. Set the mode

switch to the right (Peak) to use the rotary for peaking control. Set the mode switch to the

left (Menu) to use the rotary for menu navigation.

(2) Tally switch

This switch is used to control the tally indicators at the front of the viewfinder and the rear

of the camera handgrip. The toggle switch has three settings: Off, Low and Hi.

When the tally switch is set to the Off position, the tally indicators do not light even when

the camera is On Air.

(3) User switch C (underscan)

Set this toggle switch to On to see a scaled down (to about 85% of the area) picture in the

viewfinder. This allows for a greater viewing distance from the eyepiece. A blue border

around the picture and the message “underscan” appear. Set the switch to Off to return to

the original picture.

(4) Peaking/Menu control

With the mode switch set to Peak, turn this rotary control to adjust peaking (sharpness) of

the viewfinder picture.

With the mode switch set to Menu, push this rotary control to enter the viewfinder menu

and rotate to navigate the menu.

(5) Contrast control

Turn this rotary control clockwise to adjust the contrast of the viewfinder picture according

to your preferences. The range runs from 0 (low) to 99 (high contrast).

Menu-Peak On Off

TallyMode SW C

OffHiLow

321

4 5 6