User's Guide

45
LDX 100
User’s Guide
(13) Outside illumination (2x)
Two bright white LEDs illuminate the back panel to help locating connectors.
(14) PickMe button
This button can be configured to send an attention signal to the studio.
(15) Return B
This button can be assigned to an External/Return Video channel.
(16) Return A
This button can be assigned to an External/Return Video channel.
(17) Info button and indicator
Press and hold to view information on the viewfinder screen. 
The indicator LED in the button indicates if there is a system error or warning. When the Info
button is pushed once, the first info page with most important camera settings is shown in
combination with the IP diagnose indicators.
Press again to show the IP info page with more detailed info about the IP link. The IP
diagnose indicators stay active.
IP Off No (Q)SFP module present
Red (Q)SFP module mismatch
Yellow (Q)SFP module is present but no network link
Green (Q)SFP module is present and the network link is OK
RX Red Camera is not receiving IP Media data
Yellow Camera is receiving errors
Green Incoming IP Media data is valid
TX Green Outgoing IP Media data is enabled and delivered
Red Outgoing IP Media data is enabled but no ARP messages are
received from receiver in unicast mode, or:

unicast destination port number does not match the receiver’s port
number
Off Camera is not transmitting data (TX = 0 Mbps)
Lock Green Camera is locked
Yellow Reference signal present but camera is not locked
Red Camera is not locked
CNTRL Green Camera control link OK
Red Camera control link not valid
Off No camera control link
Indicator: Color/Status: Description: