User's Guide

Operating instructions

Camera back panel

(2) Intercom Prod volume

Headset volume for the intercom Production channel.

(3) Intercom Prog volume

Headset volume for the intercom Program channel.

(4) Intercom Eng button

This button is used to activate the intercom Engineering channel (‘talk’).

(5) Intercom Eng volume

Headset volume for the intercom Engineering channel.

(6) Call button

Press to send a Call signal to the studio. The Call indicator on the control panel(s) lights.

(7) Audio 1 indicator

This LED lights green when the audio input is set to mic sensitivity level, it lights blue when

phantom power is switched on.

(8) Audio 2 indicator

This LED lights green when the audio input is set to mic sensitivity level, it lights blue when

phantom power is switched on.

(9) Power switch

Main camera power switch.

(10) Power out indicator

This LED lights green when Power Out is available, it lights red when too much power is

drawn from the Power output connector (overload indicator).

(11) Local power indicator

This LED lights green when Local power is present and OK, it lights red when the supplied

voltage is lower than 12 VDC or higher than 17 VDC.

(12) IP diagnose indicators

Press and hold the info button at the back panel (17) or front panel to activate the IP

diagnose indicators:

Indicator: Color/Status: Description:

CABLE Yellow Camera runs in XCU mode

Purple Camera runs in NativeIP mode

Orange Camera runs in DirectIP mode