User's Guide

37
LDX 100
User’s Guide
Reference Source — select the source of the video reference to which the camera system
locks. When RefVideoIn is selected the camera system locks to the Reference input signal on
the BNC REF IN connector (can be HD Tri-Level sync or SD Black Burst), when PTP is selected
the camera system configured to lock to a PTP grandmaster reference clock on the IP Media
Network.
PTP
Status — shows PTP locking status. The following status indications are possible:
Profile — select the PTP protocol/domain used for locking to the PTP grandmaster; either
SMPTE2059, AES67, AES-SMPTE or User.
When User is selected the parameters Domain Nr, Delay Req Interval and Receipt Timeout
must be set. For more information about these paramenters, refer to the IEEE1588 PTP
(Precision Time Protocol) specification.
✎
Tip
Check the ‘Apply settings to all camera systems’ box and press OK to apply the (changed)
settings in this window to all camera systems (where applicable).
locked
XCU is locked to the PTP grandmaster clock.
calibrating
XCU has found a PTP grandmaster and is calibrating to the
grandmaster.
listening
XCU is searching for a PTP grandmaster on the IP Media
Network
disabled
PTP is switched off (for example when Reference Source =
RefVideoIn)
off
XCU is not connected to the IP Media Network.