User's Guide

6
Installation
EC 2-100 viewfinder
Caution
Do not attach a lens weighing more than 5 kg (11 lbs) to the camera without a proper lens
support.
When a new lens is fitted to the camera it may be necessary to carry out some adjustments
to optimize its use, for example, back focus or shading. For more information about these
adjustments refer to the lens manufacturer’s documentation.
☞
Note
☞
Note
If you are using a lens with an analog interface, make sure to set the lens interface type to
Analog: in the camera menu, go to the Configuration > Lens > Lens Settings menu and
use the Lens IF Type.

Always place the dust protection cap when the lens is not connected to the camera.
EC 2-100 viewfinder
Mounting the viewfinder
To mount the viewfinder on top of the camera proceed as follows:
• Loosen locking ring (2) of viewfinder support bracket (1) at the front of the camera
handgrip. (As seen from the rear of the camera, turning the locking ring
counterclockwise moves it towards the handgrip.)
• Push the locking pin (3) in and slide the viewfinder onto the viewfinder support
bracket (1).
• Tighten the locking ring (2) by turning it clockwise (as seen from rear) so that the
viewfinder is mounted securely to the support.