User's Guide

Installation

Installing a (Q)SFP module

The camera is shipped without a (Q)SFP module. Before operating the LDX 100 make sure

that the right (Q)SFP module is installed that suits your transmission configuration. Refer to

Appendix E for more information about how to install (or exchange) a (Q)SFP module.

Mounting a lens

To attach a lens to the camera head proceed as follows:

• Ensure that the lens locking ring (1) is in the unlocked position (turned

counterclockwise).

• If present, remove the dust protection cap.

• Slot the lens into the lens mount and make sure that lens and camera are accurately

aligned.

• Turn the lens locking ring (1) clockwise until the lens locks firmly into place.

• Connect the lens cable (2) to the lens connector at the right side of the camera.

• Use the cable tray (3) to stow the loop of the lens cable.