User's Guide

124
Menu references
Configuration menu
Audio 2 Source Line, Mic, Mic48V 1 — Selects source input sensitivity for the Audio 2, either
Line or Mic level or Mic level with phantom power.
Audio 2 Level -22dB, -28dB, -34dB, -
40dB, -46dB, -52dB, -
58dB, -64dB
1 — Selects input gain level for Audio channel 2 (when
Audio Gain Mode is set to Local).
Note: when Audio Gain Mode is set to Extern(al), Audio
2 Level is set by the XCU.
Audio 2 HPF Off, On 1 — Switches High Pass Filter for Audio channel 2 on or off.
Use to reduce 50 Hz and 60 Hz hum
or low frequency noise.
Audio 2 ALC Off, On 1 — Switches Auto Level Control for Audio channel 2 on or
off.
HDMI Audio Off, Audio1+2,
Audio3+4, Cam E&P,
Prog 1+2
1 — Selects which audio channels are assigned to the HDMI
audio channels.
TestTone MPB Off, ProgInt, ProgExt,
PrgMon1, PrgMon2, Eng,
Prod, Ch7, Ch8,
Mon1Sdi, Mon2Sdi,
Mon1Aes, Mon2Aes,
Ch13, Ch14, Ch15,
TstTrns, All
S — ???
TestTone Out Off, Audio 1, Audio 2,
Audio 3, Audio 4,
EngCam, ProdCam,
USB1, USB2, Audio 5,
Audio 6, MicCam,
MicTrck, AudioX, AudioY,
PrgMon1, PrgMon2, All
S — ???
Tally
Source XCU, Ethernet, IS-07,
Serial
0 O ???
On Air Lamp Enable, Disable 0 O Select Enable when the On Air Lamp/Tally light at the
front of a large viewfinder should follow the tally signal
or select Disable if you never want it to light.
On Air Lamp Lvl 0..99 (99) 0 ) Sets brightness level of the On Air Lamp/Tally light at
the front of a large viewfinder.
On Air Handgrip Switch, Input, Off 0 — ???
Aux out Off, On 0 — ???
Lock Off, On 3 — Switches the Tally Lock function on or off. When Tally
Lock is on, some camera controls are locked when the
camera is On Air.
SDI embedding Off, On 3 — ???
CAWB Settings
Function: Values: U: F: Description: