User's Guide

7
Operation
Controls
Rear panel
The rear panel gives access to the most important viewfinder controls.
Mode switch
This switch determines the function of the Menu-Peak rotary control below. Set the Mode
switch to the right (Peak) to adjust peaking level. Set the Mode switch to the left (Menu) to
use the rotary for menu navigation.
Tally switch
This switch is used to control the tally indicators at the front of the viewfinder and the rear
of the handgrip. The toggle switch has three settings: Off, Low (middle position) and Hi.
When the switch is set to the Off position, the tally indicator does not light even when the
camera is On
Air.
Switch C (underscan)
Set this toggle switch to On to see an underscan or scaled down (to approximately 85% of
the area) picture in the viewfinder. This allows for a greater viewing distance from the
Menu- Peak On Off
TallyMode SW C
Off Hi
321
87
4 5 6
1
2
3