Instruction manual

13
DRILL CHUCK REPLACEMENT
● Open chuck (1) jaws.
Unscrew the chuck xing screw with cross screwdriver, by turning it clockwise (left-hand thread). ●
Install hex key in the chuck ( ● g. D).
Gently tap free end of the hex key. ●
Unscrew the chuck. ●
Installation of the chuck is similar to deinstallation, only the sequence of actions is reversed. Drill chuck
must be rmly screwed with approx. 30 - 35 Nm torque. Check drill chuck regularly against damages.
REPLACEMENT OF CARBON BRUSHES
Replace immediately used up (shorter than 5 mm), burnt or cracked motor carbon brushes. Always
replace both brushes at a time.
Entrust replacement of carbon brushes only to a qualied person. Only original parts should be
used.
All faults should be repaired by service workshop authorized by the manufacturer.
TECHNICAL PARAMETERS
RATED PARAMETERS
Drill
Parameter Value
Supply voltage 230 V AC
Current frequency 50 Hz
Power consumption 650 W
No load rotational speed 0-3000 rpm
Clamping range 1,5-13 mm
Spindle thread 1/2’’x 20 mm
Maximum drilling diameter
steel 10 mm
wood 25 mm
concrete 13 mm
Strokes per minute 0-48000 spm
Protection class II
Weight 2 kg
Year of production 2014
NOISE LEVEL AND VIBRATION PARAMETERS
Sound pressure: Lp
A
= 96,3 dB(A) K = 3 dB(A)
Sound power: Lw
A
= 107,3 dB(A) K = 3 dB(A)
Vibration acceleration: a
h
= 15,31 m/s
2
K = 1,5 m/s
2
ENVIRONMENT PROTECTION
Do not dispose of electrically powered products with household wastes, they should be utilized in
proper plants. Obtain information on wastes utilization from your seller or local authorities. Used up
electric and electronic equipment contains substances active in natural environment. Unrecycled
equipment constitutes a potential risk for environment and human health.
* Right to introduce changes is reserved.
“Grupa Topex Spółka z ograniczoną odpowiedzialnością” Spółka komandytowa with seat in Warsaw at ul. Pograniczna 2/4 (hereinafter Grupa
Topex) informs, that all copyrights to this instruction (hereinafter Instruction), including, but not limited to, text, photographies, schemes,
drawings and layout of the instruction, belong to Grupa Topex exclusively and are protected by laws accordingly to Copyright and Related
Rights Act of 4 February 2004 (ustawa o prawie autorskim i prawach pokrewnych, Dz. U. 2006 No 90 item 631 with later ammendments).
Copying, processing, publishing, modications for commercial purposes of the entire Instruction or its parts without written permission of
Grupa Topex are strictly forbidden and may cause civil and legal liability.