Full Product Manual

14 PurePower 1800 Owner’s Guide
Installation
7. Attach the connector on the negative cable to the negative
battery terminal.
Note: This is the last cable connection. You may observe a
spark when making this last connection.
Note: Make a secure connection. Loose connectors cause
excessive voltage drop and may cause overheated wires and
melted insulation.
8. If you have installed a battery selector switch, use it to select
one of the batteries or battery banks.
9. Turn on the inverter.
10. Check the front panel of the inverter. The digital display should
show 12–13 volts, depending on the voltage of the battery. If it
does not, check your battery and the connection to the inverter.
The other indicators should be off.
EXPLOSION AND FIRE HAZARD
Do not complete the next step if flammable fumes are present.
Thoroughly ventilate the battery compartment before making this
connection.
Failure to follow these instructions will result in death or serious
injury.
PurePower 1800.book Page 14 Monday, December 12, 2016 5:06 PM