Full Product Manual

6
www.GrapeSolar.com
Tel. [phone] (toll free), 1-541-349-9000
Document Version 200722
©Copyright 2019, Grape Solar, Inc. All Rights Reserved
Connect each positive solar panel  cable to
one of the “female” fuse  ends from the
previous connections.
Connect the negative panel cables to the
“male” branch  connector ends .
Attach the bare-wire ends of the MC4-to-Bare
Wire pair  to the charge controller . The red
wire connects to the (+) input and the black
wire connects to the (-) input.
Remove the panel covering. In good sunlight,
the charge controller’s  ”BAT %” should
increase to 100%. When the controller is set to
“LOAD ON,” the system will provide power
through the load control output or through the
USB port.
7
9



Connect the 15-ft MC4 cables  to the compatible
charge controller MC4 cables .
8







GS-600-KIT-MPPT PHOTOVOLTAIC
POWER GENERATION SYSTEM
QUICK CONNECT GUIDE Rev. 200722