Installation Guide

1
2
3
Copyright 2010, Metal Roof Innovations, Ltd. S-5!
®
products are patented by Metal Roof Innovations, Ltd.
Version 100510
Installation Instructions
The S-5!
®
Mini clamps are made for a variety of standing seam profiles. When attaching to machine
folded seams (regardless of panel profile and geometry), S-5! clamps are designed to engage the
seam as shown.
On many snap-together type seams, the setscrew is opposite the open (or overlap) side of the
seam. On some seams, this aspect of clamp orientation is not critical.
Install with a screw gun and included screw gun bit tip. For optimal holding strength, screw tension
should be 160 to 180 inch pounds on 22ga steel and 130 to 150 inch pounds for all other metals
and thinner gauges of steel.
S-5! Warning! Please use these products responsibly! Visit our website or contact your S-5!
distributor for detailed installation instructions and load test results. The user and/or the installer of
these parts is responsible for all necessary engineering and design for the intended use of these
parts in an assembly or application.
Attach almost anything to standing seam metal roofs
without piercing the panel!
888-825-3432 www.S-5.com
S-5-U, S-5-S, S-5-E and S-5-B Mini Clamps