Full Product Manual

EZ Pitched Roof System

20 of 30

Installation Instructions:

EZ Roof Mount Kit K10068-XXX

1. From the marked location, move down the roof 2-1/4”

from the bottom of the shingle, and drill the pilot hole for

the Lag Bolt with a 7/32” drill bit. For maximum strength,

the hole should not be more than 3” in depth, and a drill

stop may be used to insure this.

2. Clean sawdust, and fill hole with sealant, such as Chem-

link M1 for wood and composite roofs, or ChemLink

DuraLink for metal roofs. Install AL Shoe to roof by using

5/16” Lag Bolt. Tighten to 25 ft. lbs. torque.

3. Make sure the Sealing Washer is positioned correctly on

the threaded shank of the AL Shoe. Use roofer bar to lift

roof shingle, slide the flashing under shingle, and insert

the Flashing on threaded shank as shown. For additional

waterproofing apply beads of sealant as shown.

4. Insert L-Foot to AL Shoe on top of Flashing. Place AL

Hex Cap on Shoe, and lightly hand tighten Hex Cap.

5. Install AL Rail to L-Foot to the specific orientation. Then,

tighten 3/8” Flange Nut to 15 ft-lbs. and Hex Cap to 15 ft-

lbs. torque.