Instructions / Assembly

Page
2
Tile Hook Roof Universal Mount
Installation Manual
Step 1: Attach roof hooks to the rafters
• Remove or slide up the roof tile
• Position the roof hook above the roof rafter (for high roof rafters, shim if necessary)
• Place Tile Hook in the middle of the underlying interlocking tile’s valley.
• Drill 3/16 inch pilot holes through the underlayment into the center of the rafters. Securely fasten each tile hook to the rafters with
two 5/16” x 3½” lag screws. (if spacer boards are used, lag bolts may need to be replaced with longer ones. For proper
embedment, refer to Table 2 [page 3] for lag bolt pull out values). (Fig 2)
• Slide down or re-insert the tile
Step 2: Attach L Foot to tile roof hook (Fig 3)
Figure 1
Figure 2
Figure 3
Tile Hook Components:
1 tile hook
1 stainless steel bolt
1 nut