Installation Guide

TopTile
Mounting System
18 of 27
Deck Stanchion Selection Diagram:
1. CORRECT tripod hole position:
Tripod holes are above the tile and below the collar of the
EPDM Cover.
Note: Repositioning the Tripod Stanchion higher or lower
along the tile will increase or decrease the position of the
tripod holes.
2. Acceptable tripod hole position:
Tripod holes are above the tile, yet above the collar of the
EPDM Cover. Addition Great Stuff FireBlock spray foam
can be used to prevent water infiltration.
3. INCORRECT tripod hole position:
Tripod holes are below the curve tile profile and the collar
of the EPDM Cover will not seal against the flats of the
stanchion. The TopTile Mount side screws cannot be
installed without disassembling the curved tile roof.
Correct
Acceptable
Incorrect