Instructions / Assembly

6
GS-200-KIT PHOTOVOLTAIC
POWER GENERATION SYSTEM
QUICK CONNECT GUIDE Rev. 190316
www.GrapeSolar.com
Tel. [phone] (toll free), 1-541-349-9000
Document Version 20190316
©Copyright 2019, Grape Solar, Inc. All Rights Reserved
Connect the positive panel cables  to the “female” fuse ends  from the previous connections. (TIP: to help
distinguish the two bare wire ends, place a piece of tape on this bare wire end  deriving from this positive solar
output.)
Connect the negative panel cables  to the “male” branch connector ends  of the other MC4 cable half .
Connect the positive bare wire end  to the “+” PV input of the charge controller .
Connect the negative bare wire end  to the “-” PV input of the charge controller .
Remove the panel covering. In good sunlight, the
charge controller’s  ”BAT %” should increase to
100%. When the controller is set to “LOAD ON,”
the system will provide power through the load
control output or through the USB port.
7
8







*12V load device
is not included
with kit
