Instructions / Assembly

6
GS-1080-KIT PHOTOVOLTAIC
POWER GENERATION SYSTEM
QUICK CONNECT GUIDE Rev. 190316
www.GrapeSolar.com
Tel. [phone] (toll free), 1-541-349-9000
Document Version 20190316
©Copyright 2019, Grape Solar, Inc. All Rights Reserved
IMPORTANT— READ CAREFULLY: If the AC Indicator LED on the front of the PowerHub  is off (see picture
below,) it is safe to remove the top of the inverter. Remove the 5 Philips screws to detach the inverter lid.
Remove the upper-left punchout disc on the backside of the inverter.
With the inverter  lid removed, place the charge controller ring-lug cable  ends through the punchout hole.
For this system, these ring lugs must be connected to the “WIND” INPUT. (Do not connect the charge controller
cables to the solar input.) Screw both RED ring lugs onto the positive (+) wind terminal. Screw both BLACK ring
lugs onto the negative (-) wind terminal.
7
AC light
indicator
screws
punchout
disc
front
back
+
_
top



