Instruction Manual

Rotatetheknobsothat[ ]isdisplayed,press andanother
segment[ ]willbedisplayed,
Rotatetheknobsothat[ ]isdisplayedandpress toadjust. Adjustto40°C
thenpress toaccept.
Rotatesothat[ ]isdisplayedandpressthe buttontoadjustto20minutes.
Aswearestillworkingatelevatedtemperatureswedonotrequiretherefrigeration.
Rotatetheknobsothat[ ]isdisplayed,bypressingthe button,activate relay
[ ].
Youhavenowfinishedprogramming.Press (cancel)fourtimestobringyoubackto
thedisplaywith[ ]and[ ]onit.Whentheprogramhasfinishedthe
thermostatunitwillrevertbacktothe temperature. Toadjustthispress and
adjustthetemperaturewiththeknob,thenpress again.
Youcannowruntheprogram.Press androtatetheknobuntil[ ]is
displayed.Press toselect[ ]and againtostarttheprogram.
Ifthethermalrampingasdescribedinexample1istobecarriedoutwithaGR150
thermostat,thenLabwisesoftwareisrequired.RefertoLabwiseProgramming
instructions(GrantPartNo.17093.0
Phase4
Requirement:





3InsertAfter
4
4.Temp
4Tim
4.Relays
1
Int.Temp SetPoint
Programs
Program1
S
F
SetPoint
S
4.3 Example3-GR150/(R2/R2L,R3/R3L,R4/R4L,R5)
e
introducingPhase4.

S
S
S
S
S
S
F
S
)
Page14
Lowtemperaturebath/circulator
Operatinginstructions
Version4-Jan2010