User Manual

4. Operation of BTD
You can accurately set the temperature and time required for your specific task by utilising controls
and .
In the following example we will assume that you wish to heat the microtubes to a temperature of
40°C for a time of 15 minutes.
4.1 Switch on the BTD.
4.2 Use the p and q buttons ( ) to set the temperature to 40°C.
4.3 The BTD will now start to heat up to the set temperature of
40°C. Once the temperature has been reached, allow time for
the temperature to stabilise.
4.4 Place the required microtubes into the block.
4.5 Using the p and q buttons ( ), set the timer to 15 minutes,
each press of the button will increase the time by 1minute.
00:00
00:0000:00
40.0 C
31.5 C
00:00
00:00
40.0 C
25.0 C
00:15
00:00
40.0 C
40.0 C
Page 8
BTD/BTDL
Operating instructions
1
1
2
2
00
:
1
5
00:
0
0
40.0
C
40.0
C
1
2
3
4
Version 7 - May 2011