Use Instructions

6. Initial use
Inserting the batteries
• Remove the battery compartment lid on the rear of the device.
• Insert four 1.5 V AAA (alkaline type LR03) batteries. Make sure that the batter -
ies are inserted the correct way round.
• Close the battery compartment lid again carefully.
• All display elements are briey displayed, ashes in the display. Set the
date and time as described below.
If the battery replacement symbol
is permanently displayed, you can no longer perform any measure -
ments and must replace all batteries. Once the batteries have been removed from the device, the date and
time must be set again. Any saved measurements are retained.
Making settings
You must make sure that the device has the correct settings before use in order to be able to make full use of
all functions. Only by doing so can your measurements with associated date and time be saved and accessed
later by you.
Set the hour format, date, time and Bluetooth
®
settings
It is essential to set the date and time. Otherwise, you will not be able to save your measured values correctly
with a date and time and access them again later.
• Before initial us e and after each tim e you replace the ba ttery:
• When inserting batteries into the device, you will be taken to the relevant menu automatically.
• If the batteri es have already been inserted:
• Press and hold the memory button M on the device when
for approx. 5 seconds.
In this menu you can adjust the following settings in succession:
Hour format
➔
Date
➔
Time
➔
Bluetooth
®
➔
User
Hour format
The hour format now flashes on the display.
• Using the +/- setting buttons, select your desired hour format and conrm with the M
memory button.
Date
The year ashes on the display .
• Using the +/- setting buttons, select your desired number for the year and conrm with
the M memory button.
The month ashes on the display .
• Using the +/- setting buttons, select your desired month and conrm with the M memory
button.
The day ashes on the display .
• Using the +/- setting buttons, select your desired day and conrm with the M memory
button.