Administration Guide

P a g e | 60
IPVT10 Administration Guide
Version 1.0.4.12
Cluster Settings
If users need multiple IPVT10 servers to create a cluster, users need to set one IPVT10 server as the cluster
host server.
Please, refer to the following steps:
1. Login IPVT10 Web UI.
2. Go to “Service configuration”, and configure “Cluster Settings” options。
3. Select to check the option “Active cluster service” to activate the server cluster service, and use
the IPVT10 as the cluster host server, as the figure shown below:
Figure 29: Cluster Settings
4. Users need to click to save the configuration, and click on “Apply Now” to setup the cluster host
server. Then, the cluster host server IPVT10 will be activated.
5. In the slave servers, users need to input the “Cluster Code” (e.g. “Cv1R” in the screenshot above,
case sensitive). Then, the connection between the cluster host server and slave server will be
established.
Notes:
 If the cluster service is enabled and NAT is used, the cluster port 3001 need to be configured for NAT.
 If users want to change the cluster host server to a slave server, users need to factory reset the IPVT10
device and setup the device as a slave server.
 It is recommended to connect up to 10 slave servers in order to maximize the performance of IPVT10
host server.