User Manual

Grandstream Networks, Inc. GXV3500 User Manual Page 51 of 82
Firmware Version 1.0.1.94 Last Updated: 05/2016
 Show Regions: When checked, Motion Detection region with number will be
displayed as a white rectangle in the screen. When “Edit” clicked,
the Rectangle will become Red, as shown in Figure 16-1.
 Enable Motion Detection: When checked, Motion Detection is enabled.
There are total 16 regions be available for MD configuration, from region 0 to 15.
Select and highlight the number of region to configure the MD and the sensitivity.
Alarm Action:
 Record Video From Pre Alarm Up to XXX seconds to After Alarm Up to XXX seconds:
This setting to allow configure pre/post alarm video for
applications to utilize. MJPEG is NOT supported for this feature.
 Voice Alarm to SIP Phone: If a SIP server or peer IP device configured, check this will allow
MD event to trigger alarm SIP call to pre-configured number.
 Alarm Output: Select will allow MD to send alarm to Alarm Output interface.
 Upload to Alarm Center: When checked, the alarm video will be transferred to Alarm
Center, like Grandstream free GSurf _Pro VMS software, or other
3
rd
party Alarm Center.
 Upload to Alarm HTTP Server: When checked MD alarm will be send to 3
rd
party HTTP server
via programmed Grandstream HTTP API.
• Email and FTP upload JPEG and Store it to SD driver:
When checked, snapshots of trigger moment will be emailed to
pre-configured email account and also uploaded to FTP server if
configured, will also be stored to the microSD card inserted.
The pre/post alarm snapshot numbers can be configured based on
time (in second) to meet user’s requirement.