Grandstream Networks, Inc. 126 Brookline Ave, 3rd Floor Boston, MA 02215. USA Tel : +1 (617) 566 - 9300 Fax: +1 (617) 249 - 1987 www.grandstream.com GDS3702 Intercom Access System For Warranty and RMA information, please visit www.grandstream.
Content English......................................................
EN PRECAUTIONS • Do not attempt to disassemble or modify the device. • Strictly follow the requirement of power source. • Do not expose this device to temperatures out the range of -40 °C to 70 °C for both operating and storage. • If the temperature is under -40 degree, the device will take about 3 minutes to heat up itself before booting and operating. • Do not expose this device to environments outside of the following humidity range: 10-90% RH (non-condensing).
Step 3: Make sure the ”Back Cover Frame” is in place, the wired back cover panel is good. Flush the back cover panel piece with the whole back surface of device, tighten it using the screws provided. CONNECTING THE GDS3702 Refer to the illustration below and follow the instructions on the next page. POWER OFF GDS3702 when connecting wires or inserting/removing the back cover panel piece! Step 4: Take out the two preinstalled anti-tamper screws using the hex key provided.
Option A Step 2: Run the Grandstream GS_Search tool on a computer connected to same network/ DHCP server. Step 3: Click on detection. Step 4: The detected devices will appear in the output field as below. Plug an RJ45 Ethernet cable into the (Class 3) Power over Ethernet(PoE) switch. Option B Step 1: Select an external DC12V, minimum 1A power source (not provided).
Step 6: Enter username and password to login. (The default administrator username is “admin” and the default random password can be found at the sticker on the GDS3702). GDS3702 WIRING TABLE Jack Note: For security reasons, make sure to change the default admin password from System Settings > User Management. J2 (Basic) 3.81mm J3 (Avanced) 3.81mm To obtain a CD with GPL source code information please submit a written request to: info@grandstream.
Electric Lock Type GDS3702 Connection Power On Power Off Fail Safe Lock Open Fail Secure Open Lock NOTE: * * NC2 NO2 COM2 ■ ■ ■ ■ ■ ■ ■ ■ Door Normal Status Lock Open Lock Open Please select the correct wiring based on different electric strike/lock and the normal status of door. Electric Magnetic Lock will work at Fail Safe mode ONLY. Note: 1) Power PoE_SP1, PoE_SP2 with DC, the voltage range is 48V~57V, no polarity.
