Application Guide

P a g e | 42
DP750/DP720 Administration Guide
Version 1.0.3.37
SIP Registration
Controls whether to send SIP REGISTER messages to the proxy server. Device
may not be able to make/receives calls if disabled. Default is Yes.
Unregister on
Reboot
Controls whether to clear SIP user’s information by sending un-register request to
the proxy server. The un-registration is performed by sending a REGISTER
message with “Contact” header set to * and Expires=0 parameters to the SIP
server. This will unregister all SIP accounts under concerned Profile. Default is No.
Add Auth Header
on Initial REGISTER
Adds “Authentication” header with blank “nonce” attribute in the initial SIP
REGISTER request. Default is No.
Outgoing Calls
Without
Registration
Enables the ability to place outgoing calls even when not registered (if allowed by
ITSP); device will not be able to receive incoming calls. Any HS member of a
hunting group that is not registered with a SIP account, will be able to place
outbound calls using the SIP credentials of the primary hunting group HS.
For example: HS 1, 3 and 5 are members of the same Hunting Group. HS 1 is
registered with a SIP account. HS 3 and 5 are not registered. HS 3 and 5 will be
able to place outbound calls using the SIP account of HS 1, even if Outgoing Call
without Registration is set to No. Default is No.
Register Expiration
Refreshes registration periodically with specified SIP proxy (in minutes). Maximum
interval is 65535 minutes (about 45 days). Default is 60 minutes (or 1 hour).
SIP Registration
Failure Retry Wait
Time
Sends re-register request after specific time (in seconds) when registration process
fails. Maximum interval is 3600 seconds (1 hour). Default is 20 seconds.
SIP Registration
Failure Retry Wait
Time upon 403
Forbidden
Sends re-register request after specific time (in seconds) when registration process
fails due to “403 Forbidden”. Valid range is 0 to 3600 in second. 0 second means
stop retry registration. Default is 1200 seconds.
Reregister Before
Expiration
Sends re-register request after specific time (in seconds) to renew registration
before the previous registration session expires.
Local SIP Port
Defines local port to use by the base for listening and transmitting SIP packets.
Default value for Profile 1 is 5060, 6060 for Profile 2, 7060 for Profile 3 and 8060
for Profile 4.
Use Random SIP
Port
Controls whether to use configured or random SIP ports. This is usually necessary
when multiple base stations are behind the same NAT. Default is No.
Local RTP Port
Defines local RTP port used to listen and transmit RTP packets. Default is 5004.
SIP T1 Timeout
Defines T1 timeout value. It is an estimate of the round-trip time between the client
and server transactions. For example, the base station will attempt to send a