User's Manual

Firmware Version 1.0.0.5
UCM6510 IP PBX User Manual
Page 95 of 192
 Fax
 DISA
 IVR
 By DID
When "By DID" is used, the UCM6510 will look for the destination
based on the number dialed, which could be local extensions,
conference, call queue, ring group, paging/intercom group, IVR,
voicemail groups and Fax extension as configured in "DID
destination". If the dialed number matches the DID pattern, the call
will be allowed to go through.
 Dial By Name
Strip
Specify the number of digits to strip from the beginning of the DID. This
is used when "By DID" is selected in "Default Destination".
Dial Trunk
Configure to allow the inbound call to dial out from the PBX's trunk or
not. The default setting is disabled. Please be aware of potential security
risk if "Dial Trunk" is enabled. The inbound call might be able to dial out
international calls from the PBX's trunk if allowed by the privilege level.
DID Destination
Select the DID destination if "By DID" is selected in "Default
Destination". Only the selected category can be reached by DID using
this inbound route.
 Extension
 Conference
 Call Queue
 Ring Group
 Paging/Intercom Group
 IVR
 Voicemail Groups
 Fax Extension
 Dial By Name
Time Condition
Start Time
Select the start time "hour:minute" for the trunk to use the inbound rule.
End Time
Select the end time "hour:minute" for the trunk to use the inbound rule.
Date
Select "By Week" or "By Day" and specify the date for the trunk to use
the inbound rule.
Week
Select the day in the week to use the inbound rule.
Destination
Select the destination for the inbound call under the defined time
condition.
 Extension