User's Manual
Firmware Version 1.0.0.5 
UCM6510 IP PBX User Manual 
Page 86 of 192 
Outbound Proxy Support 
Select to enable outbound proxy in this trunk. The default setting is "No". 
Outbound Proxy 
When outbound proxy support is enabled, enter the IP address or URL 
of the outbound proxy. 
Auto Record 
Enable  automatic  recording  for  the  calls  using  this  trunk.  The  default 
setting  is  disabled.  The  recording  files  can  be  accessed  under  web 
GUI->CDR->Recording Files. 
DID Mode 
Configure where to get the destination ID of an incoming SIP call, from 
SIP Request-line or To-header. The default is set to "Request-line". 
Enable Qualify 
If enabled, the UCM6510 will regularly send SIP OPTIONS to the device 
to check if the device is still online. The default setting is "No". 
Qualify Timeout 
When "Enable Qualify" option is set to "Yes", configure the timeout (in 
ms) for the Qualify SIP message. If no response is received within the 
timeout, the device is considered offline. The default setting is 1000ms. 
Qualify Frequency 
When "Enable Qualify" option is set to "Yes", configure the interval (in 
seconds) of the SIP OPTIONS message sent to the device to check if 
the device is still online. The default setting is 60 seconds. 
Fax Detection 
Enable to detect Fax signal from the trunk during the call and send the 
received Fax to the default Email address in Fax setting page under web 
GUI->PBX->Internal Options->Fax/T.38. 
Note: 
If enabled, Fax Pass-through cannot be used. 
SRTP 
Enable SRTP for the VoIP trunk. The default setting is "No". 
Table 28: IAX Trunk Configuration Parameters 
Create New IAX Trunk 
Type 
Select the VoIP trunk type. 
  Peer IAX Trunk 
  Register IAX Trunk 
Provider Name 
Configure a unique label to identify this trunk when listed in outbound 
rules, inbound rules and etc. 
Host Name 
Configure the IP address or URL for the VoIP providers server of the 
trunk. 
Keep Trunk CID 
If enabled, the trunk CID will not be overridden by extension's CID when 
the extension has CID configured. The default setting is "No". 
Username 
Enter  the  username  to  register  to  the  trunk  from  the  provider  when 










