User's Manual

Firmware Version 1.0.0.5
UCM6510 IP PBX User Manual
Page 82 of 192
VOIP TRUNKS
VOIP TRUNK CONFIGURATION
VoIP trunks can be configured in UCM6510 under web GUI->PBX->Basic/Call Routes->VoIP Trunks.
Once created, the VoIP trunks will be listed with Provider Name, Type, Hostname/IP, Username and
Options to edit/detect the trunk.
 Click on "Create New SIP Trunk" or "Create New IAX Trunk" to add a new VoIP trunk.
 Click on to configure detailed parameters for the VoIP trunk.
 Click on to configure Direct Outward Dialing (DOD) for the SIP Trunk.
 Click on to start LDAP Sync.
 Click on to delete the VoIP trunk.
The VoIP trunk options are listed in the table below.
Table 27: SIP Trunk Configuration Parameters
Create New SIP Trunk
Type
Select the VoIP trunk type.
 Peer SIP Trunk
 Register SIP Trunk
Provider Name
Configure a unique label to identify this trunk when listed in outbound
rules, inbound rules and etc.
Host Name
Configure the IP address or URL for the VoIP providers server of the
trunk.
Keep Trunk CID
If enabled, the trunk CID will not be overridden by extension's CID when
the extension has CID configured. The default setting is "No".
Username
Enter the username to register to the trunk from the provider when
"Register SIP Trunk" type is selected.
Password
Enter the password to register to the trunk from the provider when
"Register SIP Trunk" is selected.
Auth ID
Enter the Authentication ID for "Register Trunk" type.
Outbound Proxy
Enter the IP address or URL of the outbound proxy for "Register SIP