User's Manual

Firmware Version 1.0.0.5
UCM6510 IP PBX User Manual
Page 79 of 192
DIGITAL TRUNK CONFIGURATION
After configuring digital hardware, go to web GUI->PBX->Basic/Call Routes->Digital Trunks.
 Click on "Create New Digital Trunk" to add a new digital trunk.
 Click on to configure detailed parameters for the digital trunk.
 Click on to configure Direct Outward Dialing (DOD) for the digital Trunk.
 Click on to delete the digital trunk.
The digital trunk parameters are listed in the table below.
Table 26: Digital Trunk Configuration Parameters
Trunk Name
Configure trunk name to identify the digital trunk.
Channel Group
Configure the digital channel group used by the trunk.
Hide CallerID
Configure to hide outgoing caller ID. The default setting is "No".
Keep Trunk CID
If enabled, the trunk CID will not be overridden by extension's CID when
the extension has CID configured. The default setting is "No".
Caller ID
Configure the Caller ID. This is the number that the trunk will try to use
when making outbound calls. For some providers, it might not be
possible to set the CallerID with this option and this option will be
ignored.
When making outgoing calls, the following rules are used to determine
which CallerID will be used if they exist:
 The CallerID configured for the extension will be looked up first.
 If no CallerID configured for the extension, the CallerID configured
for the trunk will be used.
 If the above two are missing, the "Global Outbound CID" defined in
web GUI->PBX->Internal Options->General will be used.
CallerID Name
Configure the new name of the caller when the extension has no
CallerID Name configured.
Auto Record
Enable automatic recording for the calls using this trunk (for SIP trunk
only). The default setting is disabled. The recording files are saved in
external storage device if plugged in and can be accessed under web
GUI->CDR->Recording Files.