User's Manual

Firmware Version 1.0.0.5
UCM6510 IP PBX User Manual
Page 65 of 192
 Local Subnet Only
Only the user in specific subnet can register this extension. Up to
three subnet addresses can be specified.
 A Specific IP Address.
Only the device on the specific IP address can register this
extension.
The default setting is "Allow All".
Skip Trunk Auth
If enabled, users will not need enter the "PIN Set" required by the
outbound rule to make outbound calls. The default setting is "No".
Codec Preference
Select audio and video codec for the extension. The available codecs
are: PCMU, PCMA, GSM, AAL2-G.726-32, G.722, G.729, G.723, ILBC,
ADPCM, LPC10, H.264, H.263 and H.263p.
EDIT EXTENSION
All the UCM6510 extensions are listed under web GUI->PBX->Basic/Call Routes->Extensions, with
status, Extension, CallerID Name, Technology (SIP, IAX and FXS), IP and Port. Each extension has a
checkbox for users to "Modify Selected Extensions" or "Delete Selected Extensions". Also, options "Edit"
, "Reboot" and "Delete" are available per extension.
 Status
Users can see the following icon for each extension to indicate the SIP status.
Green: Free
Blue: Ringing
Yellow: In Use
Grey: Unavailable
 Edit single extension
Click on to start editing the extension parameters.
 Reboot the user