User's Manual

Firmware Version 1.0.0.5
UCM6510 IP PBX User Manual
Page 60 of 192
Send CallerID After
Configure the number of rings before sending CID. The default setting is
1.
Other Settings
Fax Detection
Enable to detect Fax signal from the user/trunk during the call and send
the received Fax to the Email address configured for this extension. If no
Email address can be found for the user, send the received Fax to the
default Email address in Fax setting page under web
GUI->PBX->Internal Options->Fax/T.38.
Note:
If enabled, Fax Pass-through cannot be used.
Skip Trunk Auth
If enabled, users will not need enter the "PIN Set" required by the
outbound rule to make outbound calls. The default setting is "No".
BATCH ADD EXTENSIONS
BATCH ADD SIP EXTENSIONS
Under web GUI->PBX->Basic/Call Routes->Extensions, click on "Batch Add Extensions"->"Batch Add
SIP Extensions".
Table 20: Batch Add SIP Extension Parameters
General
Start Extension
Configure the starting extension number of the batch of extensions to be
added.
Create Number
Specify the number of extensions to be added. The default setting is 5.
Permission
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Note:
Users need to have the same level as or higher level than an outbound
rule's privilege in order to make outbound calls from this rule.
Enable Voicemail
Enable Voicemail for the user. The default setting is "Yes".
SIP/IAX Password
Configure the SIP/IAX password for the users. Three options are
available to create password for the batch of extensions.