User's Manual

Firmware Version 1.0.0.5
UCM6510 IP PBX User Manual
Page 57 of 192
Only the user in specific subnet can register this extension. Up to
three subnet addresses can be specified.
 A Specific IP Address
Only the device on the specific IP address can register this
extension.
The default setting is "Allow All".
Skip Trunk Auth
If enabled, users will not need enter the "PIN Set" required by the
outbound rule to make outbound calls. The default setting is "No".
Codec Preference
Select audio and video codec for the extension. The available codecs
are: PCMU, PCMA, GSM, AAL2-G.726-32, G,726, G.722, G.729,
G.723, ILBC, ADPCM, H.264, H.263 and H.263p.
CREATE NEW FXS EXTENSION
To manually create new FXS user, go to web GUI->PBX->Basic/Call Routes->Extensions. Click on
"Create New User"->"Create New FXS Extension" and a new dialog window will show for users to fill in the
extension information. The configuration parameters are as follows.
Table 19: FXS Extension Configuration Parameters
General
Extension
The extension number associated with the user.
Analog Station
Select the FXS port to be assigned for this extension.
CallerID Number
Configure the CallerID Number that would be applied for outbound calls
from this user.
Note:
The ability to manipulate your outbound Caller ID may be limited by your
VoIP provider.
Permission
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Note:
Users need to have the same level as or higher level than an outbound
rule's privilege in order to make outbound calls using this rule.
Enable Voicemail
Enable voicemail for the user. The default setting is "Yes".