User's Manual

Firmware Version 1.0.0.5
UCM6510 IP PBX User Manual
Page 47 of 192
Figure 17: Auto Provision Settings
Table 16: Auto Provision Settings
Enable Zero Config
Enable or disable the zero config feature on the PBX. The default setting
is disabled.
Automatically Assign Extension
If enabled, when the device is discovered, the PBX will automatically
assign an extension within the range defined in "Zero Config Extension
Segment" to the device. The default setting is disabled.
Zero Config Extension
Segment
Click on the link "Zero Config Extension Segment" to specify the
extension range to be assigned if "Automatically Assign Extension" is
enabled. The default range is 5000-6299.
Enable Pick Extension
If enabled, the extension list will be sent out to the device after receiving
the device's request. This feature is for the GXP phones that support
selecting extension to be provisioned via phone's LCD. The default
setting is disabled.
Pick Extension Segment
Click on the link "Pick Extension Segment" to specify the extension list to
be sent to the device. The default range is 4000 to 4999.
Pick Extension Period (hour):
Specify the number of minutes to allow the phones being provisioned to
pick extensions.