User's Manual

Firmware Version 1.0.0.5
UCM6510 IP PBX User Manual
Page 27 of 192
SYSTEM SETTINGS
This section explains configurations for system-wide parameters on the UCM6510. Those parameters
include Network Settings, Firewall, Change Password, LDAP server, HTTP server, Email settings, Time
Settings and NTP Server settings.
NETWORK SETTINGS
After successfully connecting the UCM6510 to the network for the first time, users could login the web GUI
and go to Settings->Network Settings to configure the network parameters for the device. Select each tab
in web GUI->Settings->Network Settings page to configure LAN/WAN settings, 802.1X and Port
Forwarding.
BASIC SETTINGS
Please refer to the following tables for basic network configuration parameters on the UCM6510.
Table 5: UCM6510 Network Settings->Basic Settings
Method
Select "Route", "Switch" or "Dual" mode on the network interface of UCM6510.
The default setting is "Route".
 Route
WAN port interface will be used for uplink connection. LAN port interface will
be used to serve as router.
 Switch
WAN port interface will be used for uplink connection. LAN port interface will
be used as bridge for PC connection.
 Dual
Both ports can be used for uplink connection. Users will need assign LAN 1
or LAN 2 as the default interface in option "Default Interface" and configure
"Gateway IP" for this interface.
Preferred DNS Server
Enter the preferred DNS server address.
WAN (when "Method" is set to "Route")
IP Method
Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
Gateway IP
Enter the gateway IP address for static IP settings. The default setting is 0.0.0.0.
Subnet Mask
Enter the subnet mask address for static IP settings. The default setting is