User's Manual

Firmware Version 1.0.0.5
UCM6510 IP PBX User Manual
Page 21 of 192
Table 3: LCD Menu Options
View Events
 Critical Events
 Other Events
Device Info
 Hardware: Hardware version number
 Software: Software version number
 P/N: Part number
 WAN MAC: WAN side MAC address (UCM6510 only)
 LAN MAC: LAN side MAC address
 Uptime: System up time since the last reboot.
Network Info
 WAN Mode: DHCP, Static IP, or PPPoE
 WAN IP: IP address
 WAN Subnet Mask
 LAN IP: IP address
 LAN Subnet Mask
Network Menu
 LAN Mode: Select LAN mode as DHCP, Static IP or PPPoE
 WAN Mode: Select WAN mode as DHCP, Static IP or PPPoE
Factory Menu
 Reboot
 Factory Reset
 LCD Test Patterns
Press "OK" to start. Then press "Down" button to test different LCD
patterns. When done, press "OK" button to exit.
 Fan Mode
Select "Auto" or "On".
 LED Test Patterns
Select "All On" "All Off" or "Blinking" and check LED status for USB, SD,
T1/E1/J1, Phone 1/Phone 2, Line 1/Line 2 ports. After the LED test, select
"Back" in the menu and the device will show the LED actual status again.
 RTC Test Patterns
Select "2022-02-22 22:22" or "2011-01-11 11:11" to start the RTC
(Real-Time Clock) test pattern. Check the system time from LCD idle
screen by pressing "DOWN" button, or from web GUI->System
Status->General page. After the test, reboot the device manually and the
device will display the correct time.