User's Manual

Firmware Version 1.0.0.5
UCM6510 IP PBX User Manual
Page 145 of 192
INTERNAL OPTIONS
This section describes internal options that haven't been mentioned in previous sections yet. The settings in
this section can be applied globally to the UCM6510, including general configurations, jitter buffer, RTP
settings, hardware config and STUN monitor. The options can be accessed via web GUI->PBX->Internal
Options.
INTERNAL OPTIONS/GENERAL
Table 44: Internal Options/General
General Preferences
Global OutBound CID
Configure the global CallerID used for all outbound calls when no other
CallerID is defined with higher priority. If no CallerID is defined for
extension or trunk, the global outbound CID will be used as CallerID.
Global OutBound CID Name
Configure the global CallerID Name used for all outbound calls. If
configured, all outbound calls will have the CallerID Name set to this
name. If not, the extension's CallerID Name will be used.
Operator Extension
Specify the operator extension, which will be dialed when users presses
0 to exit voicemail application. The operator extension can also be used
in IVR option.
Ring Timeout
Configure the number of seconds to ring an extension before the call
goes to the user's voicemail box. The default setting is 60.
Note:
This is the global value used for each extension if "Ring Timeout" field is
left empty on the extension configuration page.
Record Prompt
If enabled, users will hear voice prompt before recording is started or
stopped. For example, before recording, the UCM6510 will play voice
prompt "The call will be recorded". The default setting is "No".
Extension Preferences
Enforce Strong Passwords
If enabled, strong password will be enforced for the password created on
the UCM6510. The default setting is enabled.
Strong Password Rules:
1. Password for voicemail, voicemail group, outbound route, DISA,
password, call queue and conference requires non-repetitive and
non-sequential digits, with a minimum length of 4 digits. Repetitive