User's Manual

Firmware Version 1.0.0.5
UCM6510 IP PBX User Manual
Page 143 of 192
Pickup Extension
 Default Code: *8.
 This code is for the pickup group which can be assigned for
each extension on the extension configuration page.
 If there is an incoming call to an extension, the other
extensions within the same pickup group can dial *8 directly to
pick up the call.
Direct Dial Voicemail Prefix
 Default Code: *
 This code is for the user to directly dial or transfer to an
extension's voicemail.
 For example, directly dial *5000 will have to call go into the
extension 5000's voicemail. If the user would like to transfer
the call to the extension 5000's voicemail, enter *5000 as the
transfer target number.
CALL RECORDING
The UCM6510 allows users to record audio during the call. If "Auto Record" is turned on for extension or
trunk, the call will be automatically recorded when there is established call with the extension or trunk.
Otherwise, please follow the instructions below to manually record the call.
1. Make sure the feature code for "Audio Mix Record" is configured and enabled.
2. After establishing the call, enter the "Audio Mix Record" feature code (by default it's *3) followed by # or
SEND to start recording.
3. To stop the recording, enter the "Audio Mix Record" feature code (by default it's *3) followed by # or
SEND again. Or the recording will be stopped once the call hangs up.
4. The recording file can be retrieved under web GUI->Status->CDR. Click on to play the recording
or click on to download the recording file.
Figure 67: Download Recording File From CDR Page