User's Manual

Firmware Version 1.0.0.5
UCM6510 IP PBX User Manual
Page 142 of 192
 Configure the maximum interval (in milliseconds) between the
digits input to activate the feature code.
Call Park
 Default Extension: 700.
 During an active call, initiate blind transfer and then enter this
code to park the call.
Parked Lots
 Default Extension: 701-720.
 These are the extensions where the calls will be parked, i.e.,
parking lots that the parked calls can be retrieved.
Parking Timeout (s)
 Default setting: 300.
 This is the timeout allowed for a call to be parked. After the
timeout, if the call is not picked up, the extension who parks
the call will be called back.
Feature Codes
Voicemail Access Code
 Default Code: *98.
 Enter *98 and follow the voice prompt. Or dial *98 followed by
the extension and # to access the entered extension's
voicemail box.
My Voicemail
 Default Code: *97.
 Press *97 to access the voicemail box.
Agent Pause
 Default Code: *83.
 Pause the agent in all call queues.
Agent Unpause
 Default Code: *84.
 Unpause the agent in all call queues.
Paging Prefix
 Default Code: *81.
 To page an extension, enter the code followed by the
extension number.
Intercom Prefix
 Default Code: *80.
 To intercom an extension, enter the code followed by the
extension number.
Blacklist Add
 Default Code: *40.
 To add a number to blacklist for inbound route, dial *40 and
follow the voice prompt to enter the number.
Blacklist Remove
 Default Code: *41.
 To remove a number from current blacklist for inbound route,
dial *41 and follow the voice prompt to remove the number.
Call Pickup on Ringing
 Default Code: **.
 To pick up a call for any extension xxxx, enter the code
followed by the extension number xxxx.