User's Manual

Firmware Version 1.0.0.5
UCM6510 IP PBX User Manual
Page 132 of 192
DISA
The UCM6510 supports DISA to be used in IVR or inbound route. Before using it, create new DISA under
web GUI->Call Features->DISA.
 Click on "Create New IVR" to add a new DISA.
 Click on to edit the DISA configuration.
 Click on to delete the DISA.
Figure 61: Create New DISA
Table 41: DISA Settings
Name
Configure DISA name to identify the DISA.
Password
Configure the password (digit only) required for the user to enter before
using DISA to dial out.
Note:
The password has to be at least 4 digits.
Permission
Configure the permission level for DISA. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal". If the user tries to dial
outbound calls after dialing into the DISA, the UCM6510 will compared
the DISA's permission level with the outbound route's privilege level. If
the DISA's permission level is higher than (or equal to) the outbound